KlevaKlip Systems Pty Ltd - Klevaklip Building Products

Clever Building Products Making Deck Building Easier

Did you know that approximately fifty percent of decks in Australia are built less than one metre off the ground?

KlevaKlip has commenced release of a range of purpose-built building products designed to make the building of these low-lying decks faster, easier and less hassles.

The Adjustable Joist Support – for decks over concrete slabs - the Adjustable Bearer Support - for decks approx. 300mm to 600mm off the ground - the Joist Connector for attaching 45mm wide joists to 45mm,70mm,90mm Bearers and the new FREP Joist Hanger ( Fibre Reinforced Engineering Polymer) suits 90mm x 45mm & 140mm x 45mm Joists. 

 Download Brochure‚Äč

 Check out this intro video:

Adjustable Joist Support

Watch our Joist Support Installation

The Adjustable Joist Support has been designed specifically to enable decks to easily be built over concrete slabs in areas where limited ground clearance is available. It is ideal for use when the step-down from your door to your concrete slab is between 100mm / 4 inches (minimum) and around 260mm /10 inches (maximum).

There are two types of Adjustable Joist Supports the AJH45G has been specifically designed to be used with 45mm wide treated pine timber joists for the Australian & New Zealand markets and the AJH38G (metrically measured) has been specifically designed to be used with 2 inch wide pressure treated timber joists for US markets.

Keeps your joists off the concrete and free of unwanted moisture ingress.This prevents joist-rot through the bottom of joists.

Is ideal for use on area where the concrete has built in "fall" - to provide a level deck.

Quick and easy to use – purpose-built for the application

Gives a neat, professional look across your deck structure without  resorting to various different packers and   brackets to achieve your end result. 

Uses standard 10mm hex head bolts, nuts and washers and 12mm dynabolts or 10mm masonry bolts  "off the shelf" from your hardware store.  

 


NEW FREP Joist Hanger

Watch our NEW FREP Joist Hanger Install Video

Finally there is a reasonably priced, corrosion-proof joist hanger on the market.

The new FREP Joist Hanger ( Fibre Reinforced Engineering Polymer) is strong- engineered to last, light weight, easy to use, has no sharp edges, and will not corrode in any environment.

NJH9045 suits 90mm x 45mm Joists upwards

NJH14045 suits 140mm x 45mm Joists upwards


Adjustable Bearer Support

Watch our Bearer Supports Installation

Every deck starts with the process of getting the substructure right - if it isn't properly spaced out and level, the chances of building the deck correctly are almost zero.

Therefore time must be spent on getting the posts or piers set to the correct height across the deck - a job made even more difficult if the ground is not level. 

The clever people from KlevaKlip have introduced the Adjustable Bearer Support.

Extremely easy-to-use, and suited for decks up to approximately 600m off the ground, the Adjustable Bearer Support allows you to be much less critical with your height measurements in the knowledge that you can simply wind the bearer support up or down to set your perfect height.

It will save lots of time and make your job so much easier.  


Joist Connectors

Watch our Joist Connector Installation

The range of KlevaKlip Joist Connectors have revolutionised the way joists are attached to bearers.

 An absolute must for every handyman and quickly becoming the preferred fixing method of many builders, the

Joist Connector makes the set-out and fixing off of your substructure a breeze.


Copyright © 2017 KlevaKlip Systems Pty Ltd
http://klevaklip.com.au/printed.aspx?active_page_id=417